Welcome to Twocanoes Knowledge Base

The Twocanoes forum is the best place to find information about Winclone, Boot Runner, or any other software. Post a question or share information about Twocanoes Software products. We will attempt to answer any unanswered questions within 2-3 business days. If you need an answer more quickly, consider upgrading to Pro Support for 1 business day response time. Winclone can be upgraded to Winclone Pro right in the app.

If you have Winclone Pro, submit a request on the Pro Support page.

Follow

Adding Geohopper Beacon

To add a location to Geohopper, open Geohopper.

On the Home screen, press “New” on the top right hand corner of the screen.

 

 

Select “Beacon”. Geohopper will prompt you to plug in your beacon to start configuring.

 

Next, plug your Beacon into a power source.

 

Geohopper will recognize your Beacon and display the name "Beacon" in the list. If Geohopper does not recognize your Beacon, please try unplugging and plugging the Beacon back into its power source. If the Beacon is still not discoverable, please view our video “Troubleshooting” iBeacon.

 

Select the Beacon. Geohopper will read the Beacon’s settings.

 

If this beacon has already been configured, you will be prompted to use the existing settings or set it up again with new settings.  Note that you can only set it up with new settings if you are using the same iOS device that was used to set it up initially.  The reason for this is that the password generated for the beacon is stored in the keychain just on that device.  

 

If successful, you will be directed to the Beacon's settings. 

You can change the name of your Beacon by enter it into the Beacon Name panel.

 

Click ‘Done’ to save the Beacon.

 

The Beacon will now display in your Geohopper Home screen. 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk